Running server 2016.
I have an ISCSI target that this server connects to. After a reboot, the drives do not automatically reconnect. If I disconnect them in ISCSI then reconnect, they appear fine.
When the system comes up the iSCSI init properties Target tab says it is connected. The Volumes and Devices tab has 2 long strings that should be G:\ and H:\. I click Auto Configure and the strings go away. After I disconnect and reconnect, the drives show correctly in the Volumes and Devices tab.
I cannot find anything in the event viewer that would point to what could cause this issue but I could be looking in the wrong place too.
Any suggestions?
Thanks
Charles