Hi,
I'm using an iScsi storage device that is connected to the network via two interfaces. One interface is using ip address 192.168.101.8 and the second one is 172.30.0.250. The second one is a bonded interface and I do not want to make an iscsi connection via this particular interface. So I've setup an iscsi connection on my Windows Server 2012 R2 with the target being 192.168.101.8. This works works fine but as soon as I restart my server the target gets set back to 172.30.0.250.
When I'm in iScsi Initiator in the Target tab it shows that the target is connected. When I click Properties I notice that the Identifier that I created is gone and replaced with the old Identifier again. So basically the session that I manually added is removed and restart, and the original session with the wrong target is restored.
Can I make sure that is keeps this session even after restarting the server ?
Thanks
Joeri